If you check this option, Diamonds will print a detailed image similar to the detailed results. The orientation of the model is not relevant for this tab page. But you can indicate for which elements an image should be generated in the General tab.
Below that, you’ll find the buttons representing the results. Choose for example the deformations.
Below that, you’ll find the corresponding partial results. Choose for example the subresult for deformations in the X-direction.
Indicate the load combinations for which you want to view the results. When you check the option , all load combinations from that load group will be selected. If you wish to deselect all load combinations in a load group, uncheck the option .
Diamonds shows a list of the requested results when you hoover the mouse over the corresponding button with partial results.
Insert detailed results in table If you check this option, Diamonds will print the content of the results table. With the button you can show or hide the label /mesh coordinates. For bars, specify for which position (extreme values, all mesh points, bar end points) that the results should be printed.
For a unity check (for both steel/timber), this option will the intermediary results of the unity check shown in this dialog. The resistance verification details takes up 3 pages and the buckling stability details takes up 2 pages – just for one single bar! So, think your report through and only request the design code details for the appropriate bars (see ‘General’ tab).
Insert connection verification If you check this option, Diamonds will print the content of the table “Connection verification” in the report.
. 
, all load combinations from that load group will be selected. If you wish to deselect all load combinations in a load group, uncheck the option 
.
.
you can show or hide the label /mesh coordinates.
in the report.
